Submitted by administrator on Wed, 03/04/2015 - 00:57
For certain rear shock absorbers of 4WD vehicles, the lower seat for the coil spring and the rear axle beam are not properly welded together, and the welding may give way because of vibration during driving etc., which could cause the seat to tilt and subsequently the brake pipe and the rear axle beam to interfere with each other. If the vehicle continues to be driven in such a state, the brake pipe may be damaged, and in the worst case, brake fluid could leak, resulting in reduced braking efficiency.
Case Number:
RJ-1628-0
Make/model:
Issued:
Thu, 2006-03-02
Component:
shock absorbers (rear axle beams)
Affected:
730
Correction:
The serial/lot number of the rear axle beams should be checked, and the ones to be recalled should be replaced with non-defective ones. Also, the welded sections should be checked, and the brake pipes and the brake hoses near the damaged sections should be replaced with new ones.
Identification:
yellow paint on the head of the lower bolt of the lower hinge for the right rear door
Vehicle:
Make:
Honda
Type:
UA-GD2
Period:
10/12/2003..22/12/2003
Frame / Chassis No:
GD2-1602092..GD2-1602355
Make:
Honda
Type:
UA-GD2
Period:
18/12/2003..24/12/2003
Frame / Chassis No:
GD2-8200015..GD2-8200017
Make:
Honda
Type:
UA-GD4
Period:
10/12/2003..23/12/2003
Frame / Chassis No:
GD4-1600772..GD4-1600930
Make:
Honda
Type:
UA-GD4
Period:
11/12/2003
Frame / Chassis No:
GD4-8100009
Make:
Honda
Type:
DBA-GD2
Period:
07/01/2004..17/02/2004
Frame / Chassis No:
GD2-1700001..GD2-1700533
Make:
Honda
Type:
CBA-GD4
Period:
07/01/2004..20/01/2004
Frame / Chassis No:
GD4-1700001..GD4-1700186
unique_id_feeds:
135991