Submitted by administrator on Wed, 03/04/2015 - 00:58
For the brake light switch, the measure to prevent a contact point failure in the presence of foreign material is not sufficient, and therefore, if the outside of the switch body is touched by a working glove that has handled insulating grease, the grease may gradually diffuse and reach the contact point. If this occurs and some insulating material is generated on the contact point, the braking light might fail to illuminate and it might become impossible to shift the gear lever out of the parking position.
Case Number:
RJ-1912-0
Make/model:
Issued:
Tue, 2007-07-17
Component:
brake light switch
Affected:
122 527
Correction:
The brake light switch should be replaced with the factory approved replacement unit, and the relay should be additionally installed.
Identification:
yellow paint on the upper part of the left hand side body panel inside the engine room (in front of the section where the suspension is attached)
Vehicle:
Make:
Toyota
Type:
CBA-ANM10G, DBA-ANM10G
Period:
20/09/2004..01/09/2006
Frame / Chassis No:
ANM10-0001016..ANM10-0066019
Make:
Toyota
Type:
CBA-ANM10W, DBA-ANM10W
Period:
20/09/2004..04/09/2006
Frame / Chassis No:
ANM10-0001007..ANM10-0066020
Make:
Toyota
Type:
CBA-ANM15G, DBA-ANM15G
Period:
20/09/2004..04/09/2006
Frame / Chassis No:
ANM15-0001007..ANM15-0022687
Make:
Toyota
Type:
CBA-ANM15W, DBA-ANM15W
Period:
20/09/2004..01/09/2006
Frame / Chassis No:
ANM15-0001014..ANM15-0022689
Make:
Toyota
Type:
CBA-ZNM10G
Period:
20/09/2004..04/09/2006
Frame / Chassis No:
ZNM10-0001013..ZNM10-0037295
Make:
Toyota
Type:
CBA-ZNM10W
Period:
20/09/2004..01/09/2006
Frame / Chassis No:
ZNM10-0001004..ZNM10-0037296
unique_id_feeds:
136181