Submitted by administrator on Wed, 03/04/2015 - 00:57
For the cooling water hose for the engine, its engine side end is not installed in an appropriate way, and therefore, the hose end may dislodge due to water pressure at high revs. If this problem is left unattended, the hose may interfere with the surrounding parts and be damaged, or it may come, causing the cooling water to run off, which in the worst case could result in overheating.
Case Number:
RJ-1618-0
Make/model:
Issued:
Thu, 2006-02-16
Component:
engine (cooling water hose)
Affected:
33 831
Correction:
For non-turbo vehicles, the cooling water hose should be replaced with the factory approved replacement unit that has a protector, and the clamp should be additionally installed to the hose inlet. For turbo vehicles, the clamp should be additionally installed to the hose inlet, and the harness bracket should be replaced with the factory approved replacement unit. In addition, the hose should be checked for damage, and (1) if it is not damaged, a protector should be additionally installed to it, (2) if it is damaged, it should be replaced with the factory approved replacement unit that has a protector.
Identification:
red sticker below the ID plate
Vehicle:
Make:
Suzuki
Type:
EBD-DA64V
Period:
06/08/2005..20/12/2005
Frame / Chassis No:
DA64V-100072..DA64V-119122
Make:
Suzuki
Type:
GBD-DA64V
Period:
24/08/2005..29/11/2005
Frame / Chassis No:
DA64V-600016..DA64V-600388
Make:
Suzuki
Type:
ABA-DA64W
Period:
06/08/2005..23/12/2005
Frame / Chassis No:
DA64W-100098..DA64W-114618
Make:
Mazda
Type:
EBD-DG64V
Period:
01/09/2005..29/11/2005
Frame / Chassis No:
DG64V-100002..DG64V-101339
Make:
Mazda
Type:
GBD-DG64V
Period:
30/08/2005..01/12/2005
Frame / Chassis No:
DG64V-600001..DG64V-600086
Make:
Mazda
Type:
ABA-DG64W
Period:
01/09/2005..10/12/2005
Frame / Chassis No:
DG64W-100002..DG64W-100716
unique_id_feeds:
135979