Ad

Ad 1990-99

Image: 
Alias of another review: 
Pulsar 1990-99 wagon

Ad 1999-03

Image: 
Alias of another review: 
Pulsar 1999-03 wagon

Ad 2005-13

Image: 
Alias of another review: 
Tiida 2004-13

RJ-2184-0

Submitted by administrator on Wed, 03/04/2015 - 00:58

On some vehicles, the wheel nuts may not have been adequately tightened at the factory, so their torque may not be sufficient. If this problem is left unattended, the nuts may loosen and generate abnormal noises, and in the worst case, the wheel could come off.

RJ-1834-0

Submitted by administrator on Wed, 03/04/2015 - 00:58

For the vacuum brake booster, the sprocket of the vacuum pump does not have sufficient strength, and therefore, its teeth may wear much more quickly than anticipated. If this problem is left unattended, the vacuum pump chain may come off and be stuck between the chain guides, and this could cause the rear cam sprocket to lock up, and in the worst case, the chain or the rear cam sprocket bolt could break. Either of these would cause the vacuum brake booster to stop functioning, and reduction of breaking efficiency would occur.

KJ-0329-0

Submitted by administrator on Wed, 03/04/2015 - 00:58

For the gas stays for the back door, the vehicle body end mounting parts made of resin may not have an appropriate structure, and therefore, the clips that secure the gas stay and the vehicle body end stud ball may loosen. If this occurs, the gas stay and the stud ball may separate after repeated opening/closing of the back door, and in the worst case, the gas stay might separate from the vehicle body and cause the back door to fall.

RJ-0529-0

Submitted by administrator on Wed, 03/04/2015 - 00:55

On certain mixers, which deliver the fuel to the engine, there is a manufacturing defect in the bearing of the shaft that transmits the percentage of throttle opening to the automatic transmission. Repeated operations of the accelerator pedal can cause the bearing to wear, and in the worst case, the throttle of the mixer could be stuck.

RJ-0570-0

Submitted by administrator on Wed, 03/04/2015 - 00:55

On certain vehicles running on natural gas, the seals on the opening/closing valves and the plugs of the natural gas canisters are not properly installed. If left unfixed, the seals can lose their effectiveness, and in the worst case, natural gas could leak.

RJ-0616-0

Submitted by administrator on Wed, 03/04/2015 - 00:55

The chain on the left side engine camshaft can resonate during travelling, causing excessive load on the camshaft. If this problem is left unattended, at worst, the camshaft could break, in which case the engine will stop and will not restart.

RJ-0767-0

Submitted by administrator on Wed, 03/04/2015 - 00:54

For vehicles with diesel engine, the tension guide for the timing chain driving the camshaft can be damaged by resonance of the chain due to insufficient strength, in which case it causes abnormal noise. At worst, a broken piece of the guide could be stuck in the sprocket, and the engine stops and will not restart.

Pages